General |
1. |
DC/DC converter: DC/DC converter in power supply unit
includes up/down transformer converter, and provide ignition voltage for
2 front airbag ignition circuits and the internal operation voltage of
the SRSCM. If the internal operation voltage is below critical value
setting, it will perform resetting. |
2. |
Back up power supply: SRSCM has separate back up power
supply, that will supply deployment energy instantly in low voltage
condition or upon power failure by front crash. |
3. |
Self diagnosis: SRSCM will constantly monitor current SRS
operation status and detect system failure while vehicle power supply is
on. System failure may be checked by trouble codes using GDS. |
4. |
Airbag warning lamp on: Upon detecting error, the module will
transmit signal to SRSCM indicator lamp located at cluster. MIL lamp
will notify of SRS error to the driver. Upon ignition key on, SRS lamp
will turn on for about six seconds. |
5. |
Trouble code registration: Upon error occurrence in system,
SRSCM will store DTC corresponding to the error. DTC can be cleared only
by GDS. However, if an internal fault code is logged or if a crash is
recorded, the fault code(s) cannot be cleared. |
6. |
Self diagnostic connector: Data stored in SRSCM memory will
be output to GDS or other external output devices through connector
located below driver side crash pad. |
7. |
Once airbag has been deployed, the SRSCM should not be used again and should be replaced. |
8. |
SRSCM will determine whether or not the passenger is wearing
the seat belt by examining the signal from built-in switch on the seat
belt buckle, and then deploy front seat airbag at each set of crash
speed. |
9. |
Side airbag deployment will be determined by SRSCM after
detecting satellite sensor impact signal upon a side crash, regardless
of the seat belt condition. |
10. |
SRSCM senses the vehicle rollover by using the rollover
sensor. SAB, CAB, and BPT will be able to expand if mechanic moves the
SRSCM during IGN On state. For this reason, disconnect the battery
negative cable when repairing the SRSCM. |
11. |
Check for the normal operation of SRSCM after repair procedure. |
Components and Components Location
Component Location
1. Front tilt motor2. Slide motor3. Rear height motor4. Reclining motor5. Lumbar support motor (Vertical)6. Seat cushion switch7. Seat back switch8. Lumbar support switch
...
Components and Components Location
Components
1) SVM unit basically uses C-CAN signal only to communicate about the vehicle''s condition.
•
Steering wheel angle sensor : C-CAN
•
Veh ...