Kia Optima Manuals

Kia Sedona: Sunroof Glass Repair procedures - Sunroof - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Sunroof Glass Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Sunroof / Sunroof Glass Repair procedures

Replacement
[Front]
1.
Completely open the sunroof glass (A) by pressing the sunroof switch.
2.
Remove the sunroof deflector.
(Refer to sunroof - "Sunroof Deflector ")
3.
Loosen the screw and remove the locator (A).

4.
Remove both sides of the mechanism cover (A) by pulling it in the direction of the arrow.

5.
Close the sunroof by pressing the sunroof switch until the mounting screws are visible.
6.
Loosen the mounting screw (A).
   
Do not damage the torx driver.

7.
Carefully lift up the movable glass (A) and remove it.

8.
Install in the reverse order of removal.
   
After replacing the movable glass, adjust the alignment as needed.
[Rear]
1.
Open the completely sunroof glass (A) by pressing the sunroof switch.
2.
Remove the sunroof deflector.
(Refer to sunroof - "Sunroof Deflector ")
3.
LooLoosen the screw and remove the locator (A).

4.
Remove both sides of the mechanism cover (A) by pulling it in the direction of the arrow.

5.
Completely close the sunroof glass (A) by pressing the sunroof switch.
6.
Loosen the mounting screw (A).
   
Do not damage the torx driver.

7.
Carefully lift up the movable glass (A) and remove it.

8.
Install in the reverse order of removal.
   
After replacing the movable glass, adjust the alignment as needed.
Sunroof Glass Components and Components Location
Components 1. Sunroof glass2. Rear sunroof glass ...

Sunroof Deflector Repair procedures
Replacement 1. Completely open the sunroof glass (A) by pressing the sunroof switch. 2. Loosen the sunroof deflector mounting screws. 3. Remove the sunroof deflector (A). 4. Install i ...

Other Information:

Transaxle Control Module (TCM) Components and Components Location
Component Location 1. Transaxle Control Module (TCM) ...

Hazard Lamp Switch Repair procedures
Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. Connector Pin Information No.DescriptionNo.Description1ILL+ (TAIL)2 ...

Categories


Copyright В© www.kisedona.com 2016-2024